8/7/2023 0 Comments Nintendo ds dock itAlternatively, you can contact Nintendo and send in the controller for repair. You only need a tiny square of the foam for the fix, so you can easily open up several Joy-Con controllers and apply the foam without having to buy more. It seems too easy, but the simple addition reportedly fixed the controller’s synchronization problem.Ĭonductive foam, which helps to protect against interference, is relatively inexpensive, especially compared to the cost of a replacement Joy-Con controller. After sending in a faulty Joy-Con to be repaired by Nintendo, CNET’s Sean Hollister discovered that a small piece of conductive foam was placed over the controller’s internal antenna. Nintendo hasn’t publicized it, but the manufacturer seems to have created a passable DIY hack for early adopters. Squeezing the controller, placing it behind one’s back, and covering the front of it with a hand all appear to exacerbate the problem.Īccording to multiple reports and user teardowns, the problem appears to stem from Nintendo’s decision to put the left controller’s Bluetooth antenna inside the circuit board, rather than using a discrete component, which could be positioned optimally. The Joy-Con can disconnect with the console, seemingly at random, which can be extra frustrating if it leads to being killed during a good run in Breath of the Wild. The most notorious of the Nintendo Switch’s issues thus far, disconnecting left Joy-Con controller, appears to be a fairly widespread problem. The Joy-Cons disconnect for no reason Mike Epstein/Digital Trends Mike Epstein/Digital Trends It’s an imperfect solution that could lead to some disconnections, so we recommend experimenting with several cables in order to get a tight fit. By connecting an additional USB-C cable to both the dock and the Switch - and placing the Switch on a separate stand so its vents have enough room - the console can still project its image to a television and draw power as if it were sitting in the dock directly. Provided that you have a little extra room for the Switch to sit on your shelf, a slightly more complicated option involves leaving the Switch out of the dock entirely. Etsy user TinckoyMakesitSew sells several Switch dock cozies, with themes like Mario, Zelda, classic Nintendo Entertainment System, and Pokémon, as well as several solid colors. Should you want your Switch to be protected inside the dock and look absolutely adorable, there is another option that will eliminate the need to use a screen protector altogether, assuming you won’t be traveling with the system. If you can stand spending $8 on something that you’ll remove in a few weeks once your tempered glass protector arrives, you might still want to temporarily install one of the plastic ones. In the meantime, users have taped microfiber cloths to the inside of the dock to cover up the two plastic protrusions, as well as small foam pads that cover the dock’s internal nubs. It’s advised to wait about 24 hours before docking your system after using a tempered glass protector, however, as the adhesive could melt if not allowed to set. Tempered glass covers shouldn’t suffer from this problem. However, early, flexible screen protector kits released for the system, including the “ official” PDP product, were cut incorrectly, causing bubbles. Nintendo Switch Game Vouchers: how they work and eligible gamesĪ Nintendo Switch screen protector is a must-have accessory, as any damage done by the dock will be to the removable protector and not the console itself. Nintendo Switch’s weirdest launch game is getting a surprise sequel Nintendo Direct June 2023: how to watch and what to expect
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |